Operation Manual
DVR User Manual
12
Fig 4-3 Add Device
To add IP cameras via WAN:
Step 1: Please enter MenuIP Camera tab. Refer to Fig 4-1.
Step 2: Click “Add” button to pop up a window similar to Fig 4-3. You need to check “Enable” box, select
channel, manufacturer and product model and manually input IP address, server port, username and
password of this device.
Note: If the NVR and the IP cameras you want to add are both in WAN, the IP address of the IP camera
input here must be WAN IP. You should forward the LAN IP address and port of the IP camera in the
router and use its WAN IP address, provided that the IP camera is in local area network, otherwise,
the NVR cannot connect this IP camera.
5 Main Menu Setup Guide
Click right mouse or press FN/ESC button on the front panel and then the control bar will display
at the bottom of the screen. Refer to Fig 4-1.
Fig 4-1 Main Menu Toolbar
Screen Mode: Click to select screen mode. Click the icon beside the screen display mode
to select channels. Images can drag to any place to display in the live interface.
Dwell: Dwell means to display live images from different cameras in a sequence. The images may
be displayed as a single channel or in a grid fashion from different cameras. Dwell mode is
enabled only when the chosen display mode is not able to display all the available cameras.
Color: If this button is enabled, you can adjust the color of live pictures.
E-Zoom: Single channel large screen electronic amplification.