User manual

4.6 PAN/TILT

 <AUTO STOP TIME>:

For some particular protocols, the dome will not stop moving even there is

no operation on CCTV Tester. This menu sets the time after which the dome

receives last control command.

[Off]: Disable this function

[001~255]: The time (second) that dome will stop moving without receiving

any commands.

 <SPEED AMPLIFY>:

Some protocols’ controlling speed is much lower, set <SPEED AMPLIFY> to

accelerate domes movement. Options are as below:

[Off]: Disable this function

[01×~ 32×]: Speed amplify from 01~32x

Notice: The above two functions is not available at present

 <PROPORTIONAL P/T>:

The dome moves at a certain speed (degree per second). While zoomed in,

the default movement speed may become too fast. This function decreases

the dome movement speed while zoomed in for easier control on the dome.

AUTO STOP TIME: OFF

SPEED AMPLIFY: OFF

PROPORTIONAL P/T: ON

SET NORTH

BACK

EXIT