Operation Manual

Step 2: Enter into Network interface and then click “Ethernet Connected” to check the internet connection
of Apple PC.
Step 3: After acquiring the IP address, Subnet Mask and so on, please enter into the NVR’s Main
MenuSetupNetwork interface to manually input IP address, Subnet Mask and Gateway according to
the configuration of PC. The network segment should be the same as the PC. If using DHCP, please enable
DHCP in the NVR and router.
Step 4: After finishing the above information, users can enter LAN IP and http port in the Safari browser.
For example: input http://192.168.1.100:81(here 192.168.1.100 is LAN IP of NVR, 81 is the http port of
NVR). Click “ ”button, the browser will download Active X control as shown below:
Step 5: Click icon and then select the Active X control, the welcome interface will be shown. Click
“Continue” “Install” button，the following window will pop up：