Operation Manual

Step 5: Enter into Alarm Handling tab. Refer to Fig 5-17. Select hold time and then click “Setting” button to
pop up a dialog box as shown in Fig 5-18.
Fig 5-17 Alarm Configuration-Sensor-Alarm Handling
Step 6: Enter into alarm tab to select the options to handle alarm.
Fig 5-18 Alarm Handling-Trigger
Buzzer: If selected, the local buzzer would be activated on an alarm.
Show Full Screen: If selected, there will pop up the chosen channel on the monitor on an alarm trigger.
To Alarm Out: If selected, this would trigger external relay output on an alarm.
Email: If selected, the NVR will send an email alert to the preconfigured email address in case of a sensor
based alarm from the particular input.
Snap: If selected, the system will snap images of the checked channels on an alarm and save them in the
HDD automatically.
Step 7: Enter into To Record tab. Select recording channels. It would be recorded in case of an alarm. Click
OK button to save the setting.
Step 8: Enter into Schedule tab. The setting steps for schedule for sensor based alarm are similar to normal
schedule setup. You can refer to 5.4.1 Schedule for details. This step is very important for sensor alarm.
Even if you have enabled the sensor alarm for all channels and set up the trigger, you will not see the
result of sensor alarm if no schedule is added.
If you have set schedule for sensor based recording in the same timeline, recordings can also be triggered.