Operation Manual
System Setup
5.1 Basic configuration
Basic configuration includes three sub menus: system, date & time and DST.
5.1.1 System
Step 1: Enter into MenuSetupBasicSystem. Refer to Fig 5-3:
Fig 5-3 Basic Configuration-Basic
Step 2: In this interface you can set up the device name, device ID, video format, max network user, VGA
resolution and language. The definitions for every parameters display as below:
Device Name: The name of the device as it may display on the client end or on CMS, this would help the
user to recognize the device remotely.
Device ID: This ID is used to map the NVR with IR remote controller and speed dome cameras.
Video Format: Two modes: PAL and NTSC. User can select the video format according to the cameras being
used.
Password Check: If enabled the user would need to input the user name and the password for performing
corresponding operations.
Show System Time: If selected, displays the current time during live monitoring.
Max Online Users: To set the maximum number of concurrent user logins in the NVR.
Show wizard: If selected, the GUI would launch the startup wizard on every boot, allowing user to do basic
setup.
Video Output: Resolution of live display interface.