Operation Manual

Note: If the network of IP cameras and NVR are in LAN, their IP address must be in the same
network segment. For example: If the IP address of NVR is 192.168.013.057, the IP address of IP
camera must be 192.168.013.XXX.
Step 3: Choose the searched devices and click “OK” button to add these devices. The added cameras will
be listed in the device management interface.
Step 4: Choose the camera device and click “Setup” button to enable the camera. Refer to Fig 4-3. Check
the “enable” checkbox, select channel and input the username and password of this device. Then click
“OK” to save settings.
Fig 4-3 Add Device
To add IP cameras via WAN:
Step 1: Please enter MenuIP Camera tab. Refer to Fig 4-1.
Step 2: Click “Add” button to pop up a window similar to Fig 4-3. You need to check “Enable” box, select
channel, manufacturer and product model and manually input IP address, server port, username and
password of this device.
Note: If the NVR and the IP cameras you want to add are both in WAN, the IP address of the IP
camera input here must be WAN IP. You should forward the LAN IP address and port of the IP
camera in the router and use its WAN IP address, provided that the IP camera is in local area
network, otherwise, the NVR cannot connect this IP camera.