User manual

5.5.3 Other Alarm
This tab gives a choice to configure alarm for Disk Full, IP Conflict, the Disconnect event, etc.
Step 1: Enter into Menu  Setup Other Alarm. Refer to Fig 5-21:
Fig 5-21 Other Alarm
Step 2: Use the dropdown menu and select the event or the alarm.
Step 3: Check the required trigger options.
If the selected event is “Disk Full”, then use the drop down box for “Disk Shortage Alarm” to
choose a threshold value for remaining HDD space. If the threshold value is reached, the
system will trigger the Disk Full Alarm.
Step 4: Click “Apply” to save the setting.
5.5.4 Alarm Out
Alarm out includes three sub menus: alarm out, schedule and buzzer.
To set up alarm out:
Step 1: Enter into MenuSetupAlarm Out. Refer to Fig 5-22:
Fig 5-22 System Configuration-Alarm Out
Step 2: Input relay name and select hold time.
Step 3: Enter into Schedule tab. This will go into schedule setup interface. The setting steps
for schedule for alarm out are similar to normal schedule setup (see Chapter 5.4.1 for details).