User manual

5.5 Alarm Configuration
Alarm configuration includes four sub menus: sensor, motion, other alarm and alarm out.
5.5.1 Sensor Alarm
Sensor includes three sub menus: basic, alarm handling and schedule.
Operate the following steps to configure sensor alarm:
Step 1: Enter into MenuSetupAlarm SensorBasic tab. Refer to Fig 5-16:
Fig 5-16 Alarm Configuration-Sensor-Sensor
Step 2: Enable channels by checking the checkboxes beside the desired channels.
Step 3: Set the alarm type according to triggered alarm type. Two option: NO and NC.
Step 4: Click “Apply” button to save the setting.
Step 5: Enter into Alarm Handling tab. Refer to Fig 5-17. Select hold time and then click
“Setting” button to pop up a dialog box as shown in Fig 5-18.
Fig 5-17 Alarm Configuration-Sensor-Alarm Handling
Step 6: Enter into alarm tab to select the options to handle alarm.