Operation Manual
5.3.2 Record Bitrate
Step 1: Enter into MenuSetupRecord Record Bitrate. Refer to Fig 5-11:
Step 2: Set up rate, resolution, quality, encode and max bit stream.
Step 3: Select “All” to set the same settings for all channels.
Step 4: Click “Apply” button to save the setting.
Fig 5-11 Record Configuration-Record Bitrate
If the value of the parameter is set to exceed the maximum resources of the system, the system will
automatically adjust it.
5.3.3 Time
Step 1: Enter into MenuSetupRecord Time interface to set recording time. Refer to Fig 5-12:
Step 2: Set Pre-alarm record time and post-alarm record time. Select “All” to set the same settings for all
channels.
Step 3: Click “Apply” to save the setting.
Fig 5-12 Record Configuration-Time
Parameter
Meaning
Rate
Range from: 1-30（NTSC）1-25(PAL)
Resolution
Supports1080P, 720P, VGA
Quality
The higher the value is, the clearer the recorded image is. Six options:
lowest, lower, low, medium, higher and highest.
Encode
VBR and CBR
Max bit stream
Range from: 256~12288kbps