Operation Manual

5
10. Night Mode (color / Black & White conversion):
Cameras with night mode, automatic color / monochrome conversion mode,
in accordance with changes in ambient light automatic conversion CCD
illumination. Such as: adequate lighting during the day due to the use of
general illumination to ensure colorful images. In the night illumination can
be automatically changed to black and white images show a clear interest.
11. Cruise:
Cruise can be built from several preset points. The presets for this speed
dome can be configured in consecutive order only (you may skip a
non-relevant preset, but you cannot change the order of the called
presets).Dwell durations can be configured according to the needs. The
cruise can be activated using the OSD or the RS-485 controller.
12. Pattern scanning:
Pattern scan will record any movement of the camera's ball in order to
make a consecutive scan with special characteristics.
13. Continuous scan:
Continuous horizontal scan with adjustable height and speed. It can be
triggered in power-up or RS-485 controller.
14. Random Scan:
Random horizontal scan with adjustable height and speed; unlike the
continuous scan, the random scan will shift the camera left and right and
dwell in random points. It can be triggered in power-up, by OSD or RS-485
controller.
15. Area scan
Continuous horizontal scan with adjustable height, speed and left/right
borders which the camera is confined to. It can be triggered in power-up,
by alarm or RS-485 controller.
Chapter 2 Equipment installation:
2.1DIP switch setting:
The four channel DIP switch is the baud rate and the control protocol switch.
The eight channels DIP switch is
the address setting switch.