Operation Manual

9
Figure 4
Chapter 3 System OSD menu settings:
3.1Power-On Self-Test:
When power is connected to the dome camera, the camera will move in
horizontal and vertical directions to confirm that motors and belts are in order.
The screen will show system-related information.
PTOL： PELCO-D
COMM： 2400，N，8，1
ADDR： 1
Display: PELCO-D protocol、Baud Rate 2400、Address code 1
3.2Preset point setting and calling:
3.2.1 Set Preset points:
(1) Make sure the correct camera is selected in your controller.
(2) Adjust pan, tilt and zoom to the desired location.
(3) Press the required preset number + PRESET* to preserve the scene
preset parameters.