User manual

Page 18
IP CAMERA USER MUANUAL
1. Check “Do you want IP Camera to connect Server.
2. Check the IP address and port of the transfer media server in the ECMS/NVMS. Then
enable the auto report in the ECMS/NVMS when adding a new device. Then input the
remaining information of the device in the ECMS/NVMS. After that, the system will
auto allot a device ID. Please check it in the ECMS/NVMS.
3. Input the above-mentioned server IP, server port and device ID in the responding
boxes. Click “save” button to save the settings.
5.4.5 IP Notify
1. Enter into “Network Configuration””IP Notify” to see a tab as shown in Fig 5-15.
2. If the “Enable notifying change of IP” is selected, when the IP address of the device
is changed, a new IP address will be sent to the appointed mailbox automatically; If
“FTP” is selected, when the IP address of the device was changed, a new IP address will
be sent to FTP server.
Fig 5-15 IP Notify Config
5.4.6 DDNS Configuration
1. Domain name Registration （http://provision-isr-dns.com）
Note: DDNS is used to register for a hostname with
DDNS username and password.
Provision ISR now allows you to use our mint DDNS server in order to
create a virtual address for your DVR/NVR/IP-Camera on the internet.
Each account is limited to 35 different addresses using your preferred
domain name address instead of using IP addresses. Follow the steps
below to register your DVR's name and to configure your DVR to use
Provision ISR's Mint DDNS server.
(a) To register a domain with Provision-ISR DDNS server follow these steps:
1) Visit our website:
http://provision-isr-dns.com
and register for a domain name
by clicking "Registration"