User manual

IP Camera User Manual-46
C
C
C
h
h
h
a
a
a
p
p
p
t
t
t
e
e
e
r
r
r
8
8
8
I
I
I
P
P
P
-
-
-
T
T
T
o
o
o
o
o
o
l
l
l
8 IP-Tool
Updating through IP-Tool
Note: Do not cut off power supply and internet when updating. If the device is unable to
start because of the failure of upgrade, it needs to retrofit.
Acquire the IP-Tool from the supplier and then double click the IP-Tool icon to run this
software. Then the device can be searched; if the device can’t be searched, please check
whether the PC and the device connect to the network or not.
Click the device to check its detail information as shown below:
When upgrading the software and kernel, the IP address of PC and device should be at the
same network segment. If the network segment is different, user should change the IP address
by right clicking the device and then select “network setup”. Modify IP address dialog box
will appear as follows: