User Manual

Pro Video Instruments
Vecoax Compact RF series modulator Manual
7
ADVANCE MENU – ADVANCE USERS ONLY
These are the Defaults
Please don’t change these
unless you have an
understanding of PID’s or
require a specific PID set by
your Service provider for Coax
STB injection.
Changing these numbers can
create unwanted effects to
your channel.
• DEFAULT – used to
factory reset the unit to
default.
• SERVICE-ID – Used to ID the Transport
Stream
• PMT PID - Program Map Table used to
provide information on each program
present in the transport stream, including
the program number, and list the
elementary streams
• VIDEO PID – Video ID used in the Transport
Stream to Identify the video inside the
packet identifier
• AUDIO PID - Audio ID used in the Transport
Stream to Identify the video inside the
packet identifier
• 1080P CONVERSION – Used to Downscale
1080P (Progressive) signals to 1080i
(Interlace) to Support older TV’s that don’t
support 1080P signals through the Tuner. If
you know your TV supports 1080P through
the tuner you may switch this to 1080P to
receive the full 1080P signal from your 1080P
Video Source.
• RF ATTENUATION – Default is 0DB which is
the full strength 40+DBmv from the unit. If
you require it to be lower set the RF
attenuation higher. The higher the number
the lower the signal strength will be. Ex RF
attenuation 10 would be 30+/- DBmv signal.
• FIXED EDID – This will force the unit to only
support a specific resolution so your HDMI
source is forced to only output at that
resolution set. Usual for HDMI sources that
change resolution on the fly ex DirecTV Gene
Boxes or another Cable provider STB’s.