Installation Guide
26
Use Seves Glass Block silicone sealant.
Not recommended for shower applications.
C
D
Sealant Finishing of Exterior Face
Joints
IMPORTANT:
CAUTION:
Avoid contact with skin. Safety glasses and impervious
gloves are recommended to minimize skin and eye
Do not finish the joints until
sealant has cured for 24-48 hours
Note: If you are installing blocks in a moist environment or if your wall
A. Remove any sealant squeezed out from the joints with
a utility knife.
B. Open the sealant as instructed on the tube. Coverage
rate is one tube per 16 blocks. Do not seal more joints
than you can tool in 15 minutes.
Pull the tube along the joint while laying a bead of
angle to collect the excess sealant and seal the
tool.
E. Seal the vertical joints in the same manner. Carefully
F. Let the sealant cure for 48 hours before putting any
stress on the panel.
G. Seal the perimeter joints with sealant.