Installation Guide
Make sure the blocks are straight and plumb.
J. If necessary, insert plastic shims under the channel to
channel as you insert shims.
21
K. Place a horizontal spacer with anchor inserted into the
L. Mark the location of the center of the anchor on the
jamb. If your wall has two jambs, mark the centers of
the anchors on both jambs. These marks will be used to
draw a plumb line on the jambs.
M. Removed the top horizontal spacer, block and vertical
spacers, being careful not to disturb the bottom
horizontal spacer or shims.
N. Trace the outline of the horizontal spacers and mark
the shim locations.
a level to draw a plumb line on the jambs the height
of the panel. This will be the center line for all of the
anchors.
2K
2L
2O
2M