Installation Guide
20
G. The vertical spacers for AllBend™ blocks are tapered,
is placed at the back of the AllBend™ block. The
appropriate vertical spacers are packaged with the
shaped horizontal spacers. Tridron
®
corners and EndBlock™ are standard vertical spacers.
Spacer required between two AllBend
TM
Standard spacer or 90° sharp corner, TRIDRON
®
,
and all EndBlock
™
Flat Spacer required between a 90° Radius Corner and
standard block; or vertically in jambs.
Spacer required between AllBend™ and standard block
H. If your project does not have a jamb on both ends, you
may need to temporarily prop a 2” x 4” stud at the open
end of the wall. Make sure the stud is plumb. This stud
will serve as a plumb point for you to follow as you set
blocks.
2H
2I