Warranty

ABTCO Warranty Informa on
CH WE MAY DISCONTINUE, MODIFY OR ANGE THE COLOR
OF ANY PRODUCT(S) WITHOUT NOTICE AND SHALL BEAR
NO LIABILITY FOR ANY SUCH COLOR CHANGE. IF WE
AGREE TO REPLACE PRODUCT(S) UNDER THIS WARRANTY AND AN
EXACT REPLACEMENT PRODUCT IS NOT AVAILABLE, WE MAY
SUBSTITUTE ANOTHER PRODUCT IT DEEMS TO BE EQUIVALENT IN
VALUE AND QUALITY. Any dispute concerning this warranty shall be
submi
ed to binding arbitra on to a mutually agreed arbitrator; or, if
the par
es fail to agree,
to the American Arbitra
on Associa on to
be resolved using its Commercial Arbitra
on Rules. The jurisdic on of
the arbitrator over the dispute shall be exclusive and the decision of
the arbitrator shall be binding on the par
es and nonappealable.
6. EXCLUSION OF OTHER REMEDIES IN NO EVENT SHALL WE BE
LIABLE TO ANY PERSON FOR AN AMOUNT GREATER THAN THE VALUE
OF THE REPAIR OR REPLACEMENT OF THE PRODUCT. IN NO EVENT
WILL
WE BE LIABLE FOR ANY INCIDENTAL, SPECIAL, INDIRECT,
MULTIPLE, PUNITIVE OR CONSEQUENTIAL DAMAGES RESULTING
FROM ANY DEFECT IN THE PRODUCT(S) SUPPLIED, INCLUDING, BUT
NOT LIMITED TO DAMAGE TO PROPERTY OR LOST PROFITS
REGARDLESS OF WHETHER SUCH CLAIM
S ARE BASED ON THEORIES
OF CONTRACT, WARRANTY, TORT (INCLUDING NEGLIGENCE AND
GROSS NEGLIGENCE), STRICT LIABILITY, STATUTORY LIABILITY OR
OTHERWISE. Some states do not allow the exclusion
or limita
on of
incidental or consequen
al damages, so the above limita on or
exclusion may not apply to you. WARRANTY INFORMATION CAN BE
FOUND ONLINE AT WWW.ABTCO.COM
7. RESPONSIBILITY OF PURCHASER/OWNER COMPLIANCE WITH EACH
OF THE ITEMS SET OUT BELOW IN SECTIONS A AND B INCLUSIVE IS A
CONDITION TO OUR OBLIGATIONS UNDER THIS WARRANTY AND THE
FAILURE TO COMPLY WITH ANY ONE OR MORE OF THE ITEMS SHALL
VOID ANY RIGHTS OWNER OR PURCHASER MAY HAVE UNDER THIS
WARRANTY.
A. WARRANTY CLAIMS PROCESS
(i) All claims under this Warranty must be sent in wri
ng within 45
days a
er the discovery of the defect,
and before beginning any
permanent repair, to us at KP Building Products, 402 Boyer Circle,
Williston, VT 05495. In addi
on, all of the following items must be
submi
ed at owners expense: proof of purchase, proof of ownership,
photos of siding, sample of product containing the run number.
B. OTHER
(i) The Owner must no
fy us of any change in ownership of the home
on which the Product(s) are installed within 90 days of the trans
fer of
tle.
(ii) IT IS THE OWNER’S RESPONSIBILITY TO ESTABLISH THE DATE OF
INSTALLATION. The Owner should do this by retaining any records
which would tend to prove when the Product(s) was installed,
including but not limited to: purchase invoices and receipts,
contractor’s billings, service contracts and building permits. When
required owners shall be responsible to submit all documenta
on
and siding samples at ow
ners expense.
(iii) Upon reasonable no
ce, the Owner must allow our agents to
enter the property and building on which the Product(s) is installed
to inspect such Product(s). ABTCO agents will visit the property upon
no
ce and only when deemed necessary as determined solely by
ABTCO. THE
VINYL SIDING INSTITUTE’S IMPORTANT FIRE SAFETY INFORMATION
STATEMENT IS AS FOLLOWS: Exterior vinyl building materials require
li
le maintenance for many years. Nevertheless, common sense
dictates that builders and suppliers of vinyl products store handle
and install vinyl materials in a manner that avoids damage to the
product and/or structure. Owners and Installers should take a few
simple steps to protect vinyl building materials from fire.
TO HOME AND BUILDING OWNERS:
Rigid vinyl siding is made from organic materials and will melt or burn
when
exp
osed to a significant source of flame or heat. Building
owners, occupants and outside maintenance personnel should
always take normal precau
ons to keep sources of fire, such as
barbeques, and combus
ble materials, such as dry leaves, mulch and
trash, away from vinyl siding.
TO THE BUILDING TRADES, SPECIFIERS, PROFESSIONALS AND DOIT-
YOURSELF INSTALLERS: When rigid vinyl siding is exposed to
significant heat or flame,
the vinyl will so
en, sag, melt or burn, and
may thereby expose material underneath. Care must be exercised
prior to installa
on when sele ng underlayment materials because
many underlayment materials are made from organic materials. All
building materials should be installed in accordance with local, state,
and Federal building codes and fire regula
ons.
CARE AND MAINTENANCE While ABTCO vinyl siding remains virtually
maintenance-free, it will become dirty as any other product which is
exposed to atmospheric condi
ons. Normally, your ABTCO vinyl
siding can be cleaned sa
sfactorily through the use of an ordinary
garden hose. If stubborn stains cannot be removed with water, the
following procedure should be used:
1. Equip the garden hose with a so
-bristled, long handle car brush.
2. Where soil is of a stubborn nature, the following cleani
ng solu
on
works well: - 1/3 cup household detergent - 2/3 cup trisodium
phosphate - 1 gallon water
In certain geographic areas where mildew may be a problem,
subs
tute one quart of 5% sodium hypochloride (household bleach)
for one quart water in the above formula. Where the house is
extremely dirty, it is recommended that you start washing from the
bo
om and go to the top, rinsing frequently. Cleaning solu ons
should be per
mi
ed to stand on the surface of the siding for several
minutes before rinsing. All ques
ons concerning the meaning or
applicability of this limited warranty are to be decided under the law
of the State of Oregon without reference to its choice-of-law rules.
This Warranty gives you specific legal rights, and you may also have
other rights which vary from state to state.
For further informa
on, contact: KP Building Products Quality
Assurance Manager 402 Boyer Circle Williston, VT 05495 ABTCO and
all other company names and product names are trademarks or
registered trademarks of KP Building Products. ©2018 KP Building
Products Corp. All rights reserved.