User Manual

2 CARACTERISTIQUES

11 END POINT / EXPONENTIAL MENU

Your transmitter offers advanced control features of end point of each channel as well as exponential, grouped in the

menu EP:EX.

To access this menu, press the EXIT button pressed simultaneously and turn the transmitter on.

EP:EX menu will appear on the screen indicating that you can adjust end point for each channel or the response curve

of the 3 axes (channels 1, 2 and 4).

Press ENTER to access the submenu end point EPA or EXIT button to access the Exponential EXP setting submenu as

shown in the graph below.

11.1 END POINT

1/ Hold EXIT button then turn your transmitter on simultaneously. The menu EP:EX appears.

2/ Press the ENTER button to enter the submenu end point settings. EPA is displayed on the screen for a second and then

gives way to display the running value of channel 1, set by default to 100%.

3/ Select the channel you want to adjust by pressing as many times as necessary the ENTER button, which scrolls the

channel number displayed at the top of the screen from: 1, 2, 3, 4, 5, 6.

4/ Press the UP or DOWN button to set the value from the following options:

50%, 60%, 70%, 80%, 90%, 100%, 110%, 120%. See the effect of your settings in real time on the servo

concerned.

5/ Press the EXIT button to exit and save your settings and switch power off before turning it back to use it.

Note that this setting affects the total travel of the corresponding servo and can be combined with the Dual / Rate.

11.2 EXPONENTIAL

1 / Press and hold the EXIT button simultaneously and turn the transmitter on. The menu EP:EX appears.

2 / Press the EXIT button to access the exponential adjustment submenu. EXP is displayed on the screen for a second and

then gives way to display the exponential value of channel 1, set by default to 0%.

3 / Select the channel you want to adjust by pressing as many times as necessary the ENTER button, which scrolls the

channel number displayed at the top of the screen from: 1, 2, 4.

4 / Press the UP or DOWN button to set the desired exponential value from the following options: -60%, -45%, -30%, -

15%, 0%, 15%, 30%, 45%, 60 %. See the effect of your settings in real time on the servo concerned.

5 / Press the EXIT button to exit and save your settings and switch power off before turning it back to use it.

ENTER

EXIT

ENTER