User Manual

CONTROL MODE SETTING

Your transmitter offers 4 different control modes named MODE 1 to MODE 4. The control mode of a transmitter sets the

distribution of the four axes of control on both sticks as follows :

Your transmitter offers an exclusive feature to change control mode without opening the transmitter to operate on the

mechanical sticks.

This device consists of a MODE slide button located on the back of the transmitter above the battery housing.

PROCEDURE

1/ Place the MODE button on the back of the transmitter to the desired position (MODE 1 for Mode 1 and Mode 3 or

Mode 2 for MODE 2 and MODE 4)

2/ Hold the ENTER and EXIT keys pressed simultaneously then turn the transmitter ON

3/ Press UP or DOWN keys to set the control mode to the desired value. This value is displayed in the upper left of the

screen.

If the MODE button is set to MODE 1, you can choose between Mode 1 and Mode 3.

If the MODE button is set to MODE 2, you can choose between Mode 2 and Mode 4.

4/ Turn your transmitter OFF.

2 CARACTERISTIQUES

Your transmitter allows you to define the distribution of functions with the MODE menu.

To access this feature, hold the ENTER and EXIT keys pressed simultaneously then turn the transmitter on.

The MODE menu is displayed on the screen

8 STICK MODE SETTING

The transition from Mode 1 to Mode 2 or Mode 3 Mode

4 causes a reversal of Gas and Ailerons.

The transition from Mode 1 to Mode 3 leads in turn

reversing the direction and Ailerons.

Modes 1 and 3 position the stick throttle right.

Modes 2 and position the stick throttle left

UP/DOWN

CH 3

CH 2

MODE 1

CH 3

CH 2

MODE 3

CH 2 CH 3

MODE 2

CH 2

CH 3

MODE 4