Manual

OMPLTV32.book Page 3 Friday, June 10, 2005 8:48 AM
the Display
The display requires a stable, level, and clean surface near a power outlet, 10 cm (4") away from
walls or other large objects. The rear ventilation grid should be unobstructed, and the display
should not be exposed to water or heat. Before setting up the display, prepare such a space.
To set up the display:
1. Remove the power cord and DC power adapter from the
accessories box.
Insert the appropriate end of the cord into the power
connector on the DC power adapter, then insert the
other end into a free power outlet.
The blue light on the DC power adapter should come on.
If it doesn't, check that the cord is securely connected
and that the power outlet works properly.
Insert the DC power adapter's cord into the power connector
on the bottom of the display.
Note: Make sure you plug the power connector into the
display with the arrow on top. Failure to do so will
cause a short circuit.
Connecting to a TV Signal Source
A TV signal may come from a cable box, satellite receiver,
antenna, or similar device.
To connect a TV signal source to the display:
1. Connect a coax cable between the antenna jack on the
bottom of the display and the signal source (that is, the
cable box, satellite receiver, or antenna).
Note: If you would like to be able to record the TV signal with a VCR or similar device, connect
the signal source to the input of the recording device with one cable, then connect the
output of the recording device to the antenna jack on the display with another cable.