Manual

OMPLTV32.book Page 11 Fridav June 10. 2005 8:48 AM
Display for the First Time
When you turn on your LCD for the first time, you will need to set up the display for proper
operation by scanning the television spectrum for available channels.
Setting up Television Channels
If you are connecting directly to a wall jack or antenna (that is, if you are not using a cable box or
satellite receiver), you should scan the signal spectrum to weed out channels with insufficient
signal strength once the television signal is connected to the display. This will make it much
easier to navigate through the channels.
To scan the signal spectrum:
1. Turn the display on using the POWER button.
2. Change the signal source to "TV" by repeatedly pressing the SOURCE button until "TV"
shows in the top right corner of the screen.
3. Press the MENU button to bring up the On-
Screen Display (OSD).
4. Press the CH V button until TV SETUP is
highlighted, then press SETto enter the
menu.
LANGUAGESET UP>
TV SET UP >
RESET >
[
Press the CH _ button until BAND is
highlighted, then press the VOL Y button
until the appropriate selection shows: "AIR"
for an antenna, "CATV" for cable TV.
6. Press the CH V button until SCAN is
highlighted, then press the SET button to start
scanning channels. The menu will display
"SCAN" until the scan is complete.
7. Once the scan is complete, press MENU twice
to exit the OSD.
BAND lAIR ]
SCAN [ .... ] [ 391CH
ADJUST Cb [ .... ]
FINE TUNE [ O]-_-
ADD/DELETE [ADD ]
SOUND [STEREO]
BLANKING [BLACK]
¸¸¸¸¸¸¸¸¸¸2¸¸¸¸¸¸¸¸2¸¸¸¸¸¸¸¸2¸¸¸¸¸¸¸¸2¸¸¸¸¸¸¸¸2¸¸¸¸¸¸¸¸2¸¸¸¸¸¸¸¸2¸
_;_;J_i_I_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iIillI_iII