User`s manual

Using Your Display for the First Time
When you turn on your LCD for the first time, you will need to set up the display for proper
operation by scanning the television spectrum for available channels.
Setting up Television Channels
Once the television signal is connected to the display, if you are connecting directly to a wall jack
or antenna, you should scan the signal spectrum to weed out channels with insufficient signal
strength. This will make it much easier to navigate through the channels.
To scan the signal spectrum:
1. Turn the display on using the POWER button.
2. Press the MENU button to bring up the On-Screen
Display (OSD).
iiiill .........................................................................
3. Press the VOL _ button until the Channel Settings menu
shows.
4. Press the ENTER button to enter the menu.
S,
6.
Press the ENTER button again to enter the System sub-
menu.
Press the CH _ and CH Y buttons until the appropriate
system is highlighted, then press the ENTER button to
select it.
Press MENU to return to the previous menu.
Press CH V until the Auto Scan sub-menu is highlighted
and then press ENTER to select it. The display wilt
_utomatically scan all television channels for those with
You can press MENU at any time to stop the