Operation Manual

DRP 18-4 DEC FF/ PDP 20-4 DEC FF
13
GB
machine components and cause electric
shocks.
–
Switch of the power tool immediately
if the tool is blocked. Always be pre-
pared for high reaction torques that
can cause kickback.
The tool blocks if:
- the power tool is overloaded or - it be-
comes jammed in the workpiece being pro-
cessed.
–
Avoid unintentional activation. Ensure
that the on/off switch is in switched-
off position before inserting a battery.
Carrying the power tool with your finger at
the on/off switch, or inserting the battery
when the power tool is switched on, can re-
sult in accidents.
–
The machine must never be operated
when wet or located in a damp envi-
ronment.
Connect devices that you intend
to use outdoors via an earth leakage circuit
breaker (FI) with a maximum release cur-
rent of 30mA. Always use a cable approved
for outdoor use.
–
Wear suitable protection: such as ear
protection, safety goggles, a dust mask for
work which generates dust, and protective
gloves when working with raw materials
and when changing tools.
– Secure the workpiece using clamping de-
vices.
– Check the plug and the cable regularly and
should either become damaged, have
them replaced by an authorised after-sales
service workshop.
– Always guide the cable backwards away
from the machine.
– Take care when drilling into walls as there
is a danger of rupturing concealed gas/wa-
ter pipes or cutting through power cables.
6Operation
6.1 Switch on/off
On/off switch [1-7]
Press = ON, release = OFF
X The speed of the machine depends on
how far the on/off switch is pressed in.
Speed set button[1-4]
Press once = ON, press twice or press on/off
switch = OFF
6.2 Attaching the additional handle
[2]
Always use the additional handle.
Position the additional handle [2-2] on
the extension of the gearbox housing and
engage the recesses on the additional handle
in the lugs on the housing.
Turn the handle until secured in position.
X Turn the handle to adjust the position in
30° increments.
X The drilling depth can be adjusted using
the depth stop [2-1].
7 Settings
7.1 Changing the rotational direc-
tion [1-8]
• Switch to the left = clockwise
• Switch to the right = anticlockwise
7.2 Changing gear [1-6]
Only press the speed switch when the
machine is off. Otherwise there is a
danger of damaging the gearbox.
WARNING
Unauthorised voltage or frequency!
Risk of accident
X The mains voltage and the frequency of
the power source must correspond with
the specifications on the machine's name
plate.
WARNING
Risk of injury, electric shock
X Always pull the plug out of the socket be-
fore performing any type of work on the
machine!