Operation Manual

14
orcausedbytheuserorotherdamagecaused
bynotfollowingtheoperatinginstructions,orany
faultacknowledgedatthetimeofpurchase,is
notcoveredbythewarranty.
Complaintswillonlybeacknowledgedifthe
equipmenthasnotbeendismantledbeforebeing
sentbacktothesuppliersortoanauthorised
PROTOOLcustomersupportworkshop.Store
theoperatinginstructions,safetynotes,spare
partslistandproofofpurchaseinasafeplace.
Inaddition,themanufacturer’scurrentwarranty
conditionsapply.
Note
Wereservetherighttomakechangestothe
technicaldatacontainedinthisinformationas
aresultofongoingresearchanddevelopment
work.
Noise/vibration information
LevelsdeterminedinaccordancewithEN60745
aretypically:
PDP 18-2 E-1:
Drilling
Soundpressurelevel L
PA
=78dB(A)
Noiselevel L
WA
=89dB(A)
Uncertainty K=3dB(A)
Percussiondrilling
Soundpressurelevel L
PA
=99dB(A)
Noiselevel L
WA
=110dB(A)
Uncertainty K=3dB(A)
CAUTION
Operating noise
Damage to hearing
►Useearprotection!
Vibrationemissionvaluea
h
(vectorsumfor
threedirections)anduncertaintyKmeasuredin
accordancewithEN60745:
Drilling a
h
=0.8m/s
2
Percussiondrilling a
h
=14.8m/s
2
Uncertainty K=1.5m/s
2
Theemissionvaluesspecied(vibration,noise)
weremeasuredinaccordancewiththetest
conditionsstipulatedinEN60745andare
intendedformachinecomparisons.Theyare
alsousedformakingpreliminaryestimates
regardingvibrationandnoiseloadsduring
operation.
Theemissionvaluesspeciedrefertothe
mainapplicationsforwhichthepowertoolis
used.Iftheelectricpowertoolisusedforother
applications,withothertoolsorisnotmaintained
sufcientlypriortooperation,however,the
vibrationandnoiseloadmaybehigherwhenthe
toolisused.
Takeintoaccountanymachineidlingtimes
anddowntimestoestimatethesevaluesmore
accuratelyforaspeciedtimeperiod.Thismay
signicantlyreducetheloadduringthemachine
operatingperiod.
Declarations of Conformity
Impact Drill
PDP 18-2 E-1
Serial no.
625860
Wedeclareunderoursoleresponsibilitythat
thisproductisinconformitywiththefollowing
standardsorstandardizationdocuments:
EN55014‑1,EN55014‑2,EN50366,
EN60745‑1,EN61000‑3‑2,EN61000‑3‑3,
EN60745‑2‑1accordingtotheprovisionsofthe
regulations2004/108/ECand2006/42/EC.
Alltheprocedureswereappliedasvalidly
amendedatthetimeoftheissueofthis
declaration,withoutquotingthese.
Technicaldocumentationiskeptatthe
manufacturer.
10
StanislavJakeš
Researchanddevelopment
ProtoolGmbH
Wertstr.20
D‑73240Wendlingen
30.4.2010