Operation Manual

10
Original instruction GB
1 Technical Specifi cations
Stirrer MXP 1000 E EF MXP 1002 E EF MXP 1200 E EF
Voltage 220 – 240 V 220 – 240 V 220 – 240 V
Frequency 50 / 60 Hz 50 / 60 Hz 50 / 60 Hz
Connected load 1020 W 1020 W 1200 W
Idling speed
1st speed 360 – 630 rpm 360 – 630 rpm 360 – 630 rpm
2nd speed – 580 – 1010 rpm –
Electronic speed preselection • • •
Temperature-dependent
overload protection
– • •
2-speed switch – • –
Tool adapter M14x2/ErgoFix M14x2/ErgoFix M14x2/ErgoFix
Stirrer –
max 120 mm 120 mm 140 mm
Collar – 57 mm 57 mm 57 mm
Weight 4.5 kg 4.9 kg 4.5 kg
Protection rating II / II / II /
Table of contents
1 Technical Specifi cations........................ 10
2 Symbols ............................................ 10
3 Operating equipment ........................... 10
4 Intended use ...................................... 10
5 Safety instructions .............................. 11
5.1 General safety instructions ................... 11
5.2 Safety warnings .................................. 11
5.3 Other safety risks ............................... 11
5.4 Information about noise and vibrations ... 11
6 Starting up and using the machine ........ 12
6.1 Tightening the stirrer ........................... 12
6.2 Switching the machine on and off .......... 12
6.3 Control electronics .............................. 12
6.4 Speed selection switch ......................... 12
6.5 ErgoFix interface ................................. 12
6.6 Stirrer ............................................... 13
6.7 Mains connection ................................ 13
6.8 Stationary use .................................... 14
6.9 Suction .............................................. 14
7 Service and maintenance ..................... 14
8 Service .............................................. 14
9 Environmental Protection / Disposal ........ 14
10 Warranty ........................................... 15
11 Declaration of Conformity .................... 15
2 Symbols
Double insulation
Warning of general danger
Risk of electric shock
Wear ear protection!
Read the instructions
Not to be included in municipal refuse
► Advice or tip
3 Operating equipment
[1-1] Right handle
[1-2] Left handle
[1-3] Switch with switch protection
[1-4] Locking button
[1-5] Speed control
[1-6] Collar
[1-7] Casing
[1-8] ErgoFix adapter
[1-9] Speed selection switch (MXP 1002 E EF)
[1-10] Ventilation opening
Accessories that are illustrated or described here
are not always included in the scope of delivery.
4 Intended use
The device is designed for mixing powdered mate-
rials, such as mortar, plaster, adhesives and non-
solvent paints, varnishes and similar substances.
The manufacturer accepts no liability for possible
damage or accidents caused by using or operating
the device inappropriately or incorrectly.