User`s guide

238 DC 900-1340I
BSC Programmer’s Guide
To run the test program, perform the following steps:
1. Make sure the server TSI configuration parameter is correctly defined in the TSI
text configuration file for each TSI connection definition. Refer to the Freeway
Transport Subsystem Interface Reference Guide.
2. Make any required changes to the DLI text configuration file for DLI session
parameters or ICP link parameters whose values differ from the defaults (for
example, the
elecInterface parameter for a Freeway 1000). Refer to the Freeway
Data Link Interface Reference Guide and to Chapter 7 of this guide.
3. Be sure you are in the correct directory.
For UNIX: cd /usr/local/freeway/client/test/bsc3780
or: cd /usr/local/freeway/client/test/bsc3270
For VMS: SET DEF SYS$SYSDEVICE:[FREEWAY.CLIENT.TEST.BSC3780]
or: SET DEF SYS$SYSDEVICE:[FREEWAY.CLIENT.TEST.BSC3270]
For NT: cd c:\freeway\client\test\bsc3780
or: cd c:\freeway\client\test\bsc3270
4. Run the make file provided in the test directory.
For UNIX: make -f makefile.<op-sys> all
where <op-sys> is the operating system:
sun (for a Sun system)
Table E– 2: BSC 3780 Loopback Test Programs and Directories
Operating System Program BSC 3780 Test Directory
UNIX bsc3780alp.c usr/local/freeway/client/test/bsc3780
VMS
BSC3780ALP.C
SYS$SYSDEVICE:[FREEWAY.CLIENT.TEST.BSC3780]
Windows NT
bsc3780alp.c c:\freeway\client\test\bsc3780
3/97 Leslie: A
decision was
made by Eric
Loos and
Mark Attaway
to leave in all
the references
to non-
supported
platforms (in
the name of
user
friendliness).
However, I
did change all
the examples
to use only
supported
platforms.
Supported
platforms are:
VAX VMS
UCX 6.x,
AXP VMS
UCX 6.x,
Solaris 2.5.x,
HP-UX 10.x,
AXP
Windows NT
3.51, and Intel
Windows NT
3.51,