User`s guide

236 DC 900-1340I
BSC Programmer’s Guide
–131
DLI_ICP_ERR_STATION_DOWN
A 3270 remote station has changed status from a logi-
cally active state to an inactive one. For control sta-
tions, this means that a remote tributary station failed
to answer a general poll sequence within a required
number of retries. The control unit number of the
tributary station is placed in the CU byte of the
pOptArgs.usCircuitID field of the error report. For trib-
utary stations, this means that the remote control sta-
tion failed to issue a poll or select sequence within the
timeout period specified by the interpoll delay option.
–132
DLI_ICP_ERR_LINE_UP
A transmission/reception has occurred on a link that
was previous marked down.
–133
DLI_ICP_ERR_USER_ABORT
A transmission/reception was aborted after the client
issued a Stop Link command.
–134
DLI_ICP_ERR_NO_CU
No such CU in poll list.
–135
DLI_ICP_ERR_MODE_NOT_SAFE
The client issues a Send EOT command when BSC is
not expecting one, or an EOT is received from the
remote station (forward abort) before the client sends
the message acceptance/rejection.
–136
DLI_ICP_ERR_MODE_NOT_MASTER
Request command/function is available only to a
Manager session.
–137
DLI_ICP_ERR_DEVICE_BUSY
Fatal modem error; device is busy.
–138
DLI_ICP_ERR_BUSY_OUT
Busy-out is not supported.
–139
DLI_ICP_ERR_NO_ANSWER
No answer.
–140
DLI_ICP_ERR_INVALID_RESP
Unidentified modem response.
–141
DLI_ICP_ERR_NO_DIALTONE
No dial tone.
–142
DLI_ICP_ERR_BAD_MODEM_RESP
Invalid command or configuration.
–143
DLI_ICP_ERR_INCOMING_CALL
Incoming call detected.
–144
DLI_ICP_ERR_INVALID_PROTOCOL
Unknown protocol type.
–145
DLI_ICP_ERR_INBUF_OVERFLOW
Input buffer overflow
–146
DLI_ICP_ERR_OUTBUF_OVERFLOW
Output buffer overflow
–147
DLI_ICP_ERR_DISC_TIMEOUT
Disconnect timeout error
–151
DLI_ICP_ERR_BCC_PARITY
BCC and parity errors were detected
Table D–1 : BSC Error Codes (Cont’d)
Code DLI Constant Name Meaning