User`s guide

D: Error Codes
DC 900-1340I 235
–118
DLI_ICP_ERR_LINK_INACTIVE
The link is stopped.
–119
DLI_ICP_ERR_BAD_SESSID
If this error occurs, please call Protogate.
–121
DLI_ICP_ERR_NO_SESSION
No more clients are available on this ICP. This error
should never occur; if it does, please call Protogate.
–122
DLI_ICP_ERR_BAD_PARMS
The parameter value(s) used for the function call are
illegal.
–123
DLI_ICP_ERR_BAD_MODE
The function request is not available for the requested
access mode.
–124
DLI_ICP_ERR_BAD_OP
The device is not owned; no legal operations.
–125
DLI_ICP_ERR_NO_CTRL_SESS
No non-Control session is registered for this link. The
operation is not allowed.
–126
DLI_ICP_ERR_XMIT_ABORTED
The remote computer (or BSC) sent EOT. The message
is discarded.
–127
DLI_ICP_ERR_RETRY_EXCEEDED
The retry limit was exceeded while attempting to trans-
mit a data block or select a tributary station. The mes-
sage is discarded.
–128
DLI_ICP_ERR_RVI_GOOD_RECV
An RVI was received after the last (ETX) block of a
message was transmitted on the line. The message
transmission was successful. This is an informational
message only.
–129
DLI_ICP_ERR_RVI_RCV_ABORTED
An RVI was received after an intermediate (ETB) block
of a message was transmitted on the line. The message
is discarded.
–130
DLI_ICP_ERR_STATION_UP
A 3270 remote station has changed status from a logi-
cally inactive state to an active one. For control sta-
tions, this means that a remote tributary station has
responded to a general poll or select sequence. The
number of the remote tributary station is placed in the
CU byte of the
pOptArgs.usCircuitID field of the error
report. For tributary stations, this means that a poll or
select sequence has been received from the remote
control station for the control unit number specified
in the CU byte of the
pOptArgs.usCircuitID field of the
error report.
Table D–1 : BSC Error Codes (Cont’d)
Code DLI Constant Name Meaning