Installation guide

ManualsBrandsProtogate ManualsComputer equipmentFreeway 3600

Chapter 4. Qualiﬁcation Provisions

This section deﬁnes a set of qualiﬁcation methods and speciﬁes, for each requirement in

Chapter 3, methods or

procedures which can be used to ensure that the requirement has been met.

Table 4-1. Freeway Software Qualiﬁcation Methods

Section Requirement

Name

Qualiﬁcation

Method

Notes

Section 3.2.1 DLI/TSI

Server

Test Setup a Freeway with at least 2 serial datalink ports, loaded with

sps_2432b.mem, and with a loopback connector between the 2

serial datalink ports; run the spsalp loopback test.

Section 3.2.2 ICP Host Test Setup a Freeway with at least 2 serial datalink ports, loaded with

sps_2432b.mem, and with a loopback connector between the 2

serial datalink ports; run the spsalp loopback test.

Section 3.2.3 User Interface Test Login to a Freeway and traverse the user menus.

Section 3.8.1 GEN000100 -

Supported

Release

Test Login to a Freeway and execute the command uname -a, and

verify that the results match the version number listed in the

Freeway Software Version Description (SVD) - DC-900-2023

document.

Section 3.8.2 GEN000120 -

Supported

Components

Test Login to a Freeway and execute the command pkg_info, and

verify that the results match the version numbers listed in the

Freeway Software Version Description (SVD) - DC-900-2023

document.

Section 3.8.3 GEN000240 -

Network

Time-Server

Check Login to the Freeway and execute the command ps -ax |grep

"ntpd" to verify that the ntpd daemon is running, and the

command more /tmp/ntp.conf to verify that NTP

conﬁguration is as desired. If the Freeway has had time to

synchronize with other NTP servers, the command ntpq -p will

show which peers it has synchronized with. See the Freeway

Security Features User’s Guide (SFUG) - DC-908-3004

document for details about NTP.

Section 3.8.4 GEN000400 -

Logon Warning

Banner Display

Check Login to the Freeway and execute the command more

/etc/ssh/sshd_config to verify that the "Banner" keyword is

set to "/etc/motd", and the command more /etc/motd to see

the text which is displayed upon login. See the Freeway Security

Features User’s Guide (SFUG) - DC-908-3004 document for

details about the login banner.

Section 3.8.5 GEN000440 -

Logging Login

Attempts

Check Login to the Freeway and execute the command last; grep

"authentication error" /var/log/all.log to verify that

both successful and unsuccessful logins are logged. See the

Freeway Security Features User’s Guide (SFUG) - DC-908-3004

document for details about logging.