Installation guide

Chapter 5. Conﬁguring the Boot Parameters Using the Local Console

10. Use the blank form in Figure 5-3 to write down your boot parameter conﬁgurations for future reference.

Figure 5-3. Conﬁgured Freeway System Boot Parameters (Local Console)

Freeway System Boot Parameters

------------------------------

Boot Device : _____________________________________

Processor Number : _____________________________________

FTP User Name : _____________________________________

FTP Password : _____________________________________

Flags : _____________________________________

Freeway Server Name : _____________________________________

Freeway Inet Address : _____________________________________

Freeway Subnet Mask : _____________________________________

Boot Server Name : _____________________________________

Boot Server Inet Address : _____________________________________

System Boot Directory : _____________________________________

System Boot File Name : _____________________________________

Configuration File Name : _____________________________________

Secondary Net Interface : _____________________________________

Gateway Inet Address : _____________________________________

11. Run the loopback test to check the hardware and software installation as described in the Freeway Loopback

Test Procedures.

12. If Freeway will normally boot from the boot server, installation is complete. If Freeway will boot from its local

disk, you must download the ﬁles from the boot server onto the local disk. Follow the instructions in the "Build

Hard Disk from Boot Server" section in the Freeway User’s Guide.