Installation guide

Chapter 2. Getting Started

This manual describes how to install the Freeway 3600 hardware and conﬁgure the boot parameters. The following is

a summary of the complete installation procedure:

1. Install the hardware as described in Chapter 3 of this manual.

2. Install the software onto the boot server as described in the Freeway User’s Guide.

3. If you are using the boot parameter initialization disk, conﬁgure the boot parameters as described in Chapter 4 of

this manual.

4. If you are using a local console, conﬁgure the boot parameters as described in Chapter 5 of this manual.

5. Boot the Freeway server.

6. Run the loopback test as described in the Freeway Loopback Test Procedures.

7. Customize your installation, if necessary, as described in the Freeway User’s Guide.

8. Familiarize yourself with Freeway operations as described in the Freeway User’s Guide.