User`s guide

6: ICPLOAD Utility
DC 900-1516D 97
6.4.3.4 START
This command causes the ICP to begin execution of the downloaded software.
Format START device_name /STARTUP=address
Parameters device_name
This parameter specifies the ICP device to be started.
Qualifiers
/DLITE
This qualifier specifies the driver works for node auto-assign-
ment. See Section4.4 on page 79 for more information about
node auto-assignment.
/STARTUP=address
This qualifier specifies the starting execution address.
(If desired, you can use the DCL
%X prefix to denote a hexadec-
imal value.)
Description The
START command causes the ICP to begin execution of the
ICP-resident software at the specified address.
The ICP2432 can receive multiple download images, so an
explicit start request is required.
Example
ICPLOAD> START ZJA0/STARTUP=%X802000
This command causes the ICP known as ZJA0 to begin execu-
tion at address
802000 (hex).
Foreign Command
$ LDICP device_name /START=address
12/3/98 Leslie:
Ginni had the
first sentence
underlined,
but no note.