User`s guide

32 DC 900-1516D
ICP2432 User’s Guide for OpenVMS Alpha (DLITE Interface)
Note
ICPLOADVMS searches for the script file and the installed protocol
software image (for example,
fmpload and FMP_FW_2432.MEM) in
the specified directory. If not found in the specified directory, then
it searches in the
[FREEWAY.BOOT] directory. If the directory is
not specified, the current directory is used. If the script file can not
be found, ICPLOADVMS returns an error.
Step 2: Execute
ICPLOADVMS.COM to download the protocol software onto a single
ICP2432 as shown in the example below:
$ @ICPLOADVMS ZJA0 fmpload DLITE
Processing DKA200:[FREEWAY.BOOT]FMPLOAD.
Resetting ZJA0. This will take about 15 seconds...
Loading Firmware DKA200:[FREEWAY.BOOT]XIO_2432.MEM...
Loading Firmware DKA200:[FREEWAY.BOOT]FMP_FW_2432.MEM...
Starting Firmware (DLITE) ...
Step 3: Use the ICP2432_STARTUP.COM command file located in the [FREEWAY.CLI-
ENT.VMS_EMB.BIN]
directory to download multiple ICP boards or to set up to down-
load the protocol software on system startup. This file uses
ICPLOADVMS.COM to load
protocol images one or more ICP boards.
Edit the
ICP2432_STARTUP.COM file and modify the example lines to reflect your spe-
cific script file name and device name. Add lines for downloading multiple ICP boards.
The following example downloads the FMP protocol software to device ZJA0 using the
DLITE embedded interface (described in Chapter 3).