User`s guide

2: Software Installation
DC 900-1516D 31
2.6 Loading the Protocol Software
The following procedure describes how to load the protocol software into the ICP2432
boards. Note that you may load and reload the protocol software as many times as you
wish without having to reload the VMS device driver (ZJDRIVER) for the ICP2432. The
procedure also provides instruction on how to configure your system so that the proto-
col software is loaded automatically at system startup.
Step 1: To download the protocol software to a single ICP, use the command file
ICP-
LOADVMS.COM
located in the [FREEWAY.CLIENT.VMS_EMB.BIN] directory. This
command file uses the
ICPLOAD utility described in Chapter 6.
ICPLOADVMS.COM uses the script file that is placed in the [FREEWAY.BOOT] direc-
tory during protocol software installation (performed in Section 2.2). Check this direc-
tory for the script file of the protocol you wish to download.
The syntax for executing
ICPLOADVMS.COM is as follows:
$ @ICPLOADVMS device_name script_file_name dlite_flag
Where the command line parameters are defined as follows:
device_name Device name of the ICP to be downloaded
(for example,
ZJA0, ZJB0, …)
script_file_name Script file name placed in the [FREEWAY.BOOT]
directory during protocol software installation
(for example,
fmpload, spsload, …)
dlite_flag DLITE mode select flag. If you are using the DLITE
embedded interface described in Chapter 3, set the
dlite_flag to “dlite” or “DLITE”. If you are interfacing
directly to the ZJDRIVER without DLITE (non-API
mode), then leave this field blank. For more details
on the DLITE mode, see Section 4.4 on page 79.