User`s guide

78 DC 900-1317J
ADCCP NRM Programmer’s Guide
remain unacknowledged and may have been lost in transit. The client is responsible for
initiating recovery procedures at a higher level.
3.4.23 DLI_PROT_RECV_STATION_RESET_CFM Packet
The ICP uses this packet to report the completion of a station reset requested by the cli-
ent. The ICP specifies the
usProtCommand field (DLI_PROT_RECV_STATION_RESET_CFM), the
iProtModifier field, the link ID, and the usProtXParms[0] field (station ID). The
iProtModifier field indicates the station’s operational mode following the reset (see
Ta ble 3 –6 ).
After the client receives a DLI_PROT_RECV_STATION_RESET_CFM packet in response to a
DLI_PROT_SEND_STATION_RESET packet (see Section 3.4.22), the client should initiate any
higher-level data transfer recovery procedures.
3.4.24 DLI_PROT_SEND_STATION_RESET_CFM Packet
The client uses this packet to reply to a DLI_PROT_RECV_STATION_RESET packet (see
Section 3.4.21) received from the ICP. The client specifies the
usProtCommand field
(
DLI_PROT_SEND_STATION_RESET_CFM) and the usProtXParms[0] field (station ID).
After the client sends a DLI_PROT_SEND_STATION_RESET_CFM packet in response to a
DLI_PROT_RECV_STATION_RESET packet, the client should initiate any higher-level data
transfer recovery procedures.
3.4.25 DLI_PROT_RECV_LINK_EXCEPTION Packet
The ICP uses this packet to report operational exceptions on a link or station. To report
an exception, the ICP specifies the
usProtCommand field (DLI_PROT_RECV_LINK_EXCEPTION),
the
iProtModifier field, the link ID, and the usProtXParms[0] field (station ID, zeroed if
not applicable). The
iProtModifier field identifies the exception condition (see
Ta ble 3 –6 ).