User`s guide

150 DC 900-1317J
ADCCP NRM Programmer’s Guide
D.18 station-reset-packet
Packet Description
This packet is used to reset an active NRM remote secondary (primary) station. When
received by the ICP, the ICP discards all transmit buffers for the affected station. The cli-
ent is responsible for the recovery of the procedures at a higher level.
Packet Header
Freeway (DLI api only):
usFWPacketType = FW_DATA
usFWCommand = FW_ICP_WRITE
usFWStatus = 0
ICP:
usICPClientID = 0
usICPServerID = 0
[usLength = 16 (used for non DLI api only)]
usICPCommand = DLI_ICP_CMD_WRITE
iICPStatus = 0 - for Big Endian Clients or
= 0x4000 - for Little Endian Clients
usICPParams[0] = 0
usICPParams[1] = 0
usICPParams[2] = 0
Protocol:
usProtCommand = DLI_PROT_SEND_STATION_RESET
iProtModifier = 0
usProtLinkID = port number
usProtCircuitID = 0
usProtSessionID = protocol session number from "attach-packet"
usProtSequence = 0
usProtXparms[0] = station id
usProtXparms[1] = 0
Note
The Freeway header is used only with DLI (it is not applicable for
DLITE), and the
usLength field of the ICP header is used only with-
out DLI.
Data
None.
Packet Exchanges
usProtCommand sent usProtCommand received
------------------ ----------------------
DLI_PROT_SEND_STATION_RESET DLI_PROT_RECV_STATION_RESET_CFM
(see "station-reset-ack-packet" below)