User`s guide

104 DC 900-1317J
ADCCP NRM Programmer’s Guide
5.2 DLI Session Configuration
The DLI text configuration file used by the dlicfg program consists of the following sec-
tions:
• A “main” section which specifies the DLI configuration for non-session-specific
operations (described in the Freeway Data Link Interface Reference Guide)
• One or more additional sections, each specifying a protocol-specific session asso-
ciated with a particular Freeway serial communication link (port). Each link can
be configured independently of the other links. The ADCCP NRM protocol
allows multiple sessions per link.
The protocol-specific session parameters can be divided into two groups:
• Client-related parameters are described in the Freeway Data Link Interface Refer-
ence Guide. For example, each session has an associated TSI connection name
which you also specify in your TSI configuration file, though multiple sessions
can use the same TSI connection.
• Protocol-specific link parameter values which are different from the defaults
shown in Ta bl e 5 –1. These parameters are optional in the DLI text configuration
file. The
dlWrite Configure Link command described in Section 3.4.20 on page 69
also can perform protocol-specific configuration.
Figure 5–2 is an example DLI configuration file showing the “main” section and two
ADCCP NRM sessions. The DLI client-related parameters are shown in
typewriter type.
The protocol-specific parameters are shown in
bold typewriter type.You need to
include only those parameters whose values differ from the defaults. Section 3.4.20 on
page 69 describes the link configuration options in detail.
The syntax for the ADCCP NRM link configuration parameters is shown in Ta bl e 5 –1 ,
along with the defaults. The parameter names are case independent but are shown in
upper and lower case for readability.