User guide

88 DC 900-1333Q
Freeway User Guide
4.5.3.1 Display IP Network Interface Information
To display the IP network interface information as shown in Figure 4–9, enter ‘2’ at the
Display Network Information menu. This figure shows the display for a Freeway 3100
booting from the primary Ethernet interface. “elt” in the figure refers to the interface
type as defined in the Boot Device parameter of the System Boot Parameters menu
described in Section 4.6.1 on page 108. Network information for all attached interfaces
is displayed, including the boot device as well as any additional interfaces specified with
the
added_interface_type parameter in the boot configuration file.
Figure 4–9: Display IP Network Interface Information
IP Network Interface Information
--------------------------------
em0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0
mtu 1500
options=4219b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,
VLAN_HWCSUM,TSO4,WOL_MAGIC,VLAN_HWTSO>
ether 00:0b:ab:6d:15:4c
inet 192.168.1.111 netmask 0xffffff00 broadcast 192.168.1.255
inet6 fe80::20b:abff:fe6d:154c%em0 prefixlen 64 scopeid 0x1
nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL>
media: Ethernet autoselect (100baseTX <full-duplex>)
status: active
em1: flags=8c02<BROADCAST,OACTIVE,SIMPLEX,MULTICAST> metric 0
mtu 1500
options=4219b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,
VLAN_HWCSUM,TSO4,WOL_MAGIC,VLAN_HWTSO>
ether 00:0b:ab:6d:15:4d
nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL>
media: Ethernet autoselect
status: no carrier
ipfw0: flags=8801<UP,SIMPLEX,MULTICAST> metric 0 mtu 65536
nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL>
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> metric 0 mtu 16384
options=600003<RXCSUM,TXCSUM,RXCSUM_IPV6,TXCSUM_IPV6>
inet 127.0.0.1 netmask 0xff000000
inet6 ::1 prefixlen 128
inet6 fe80::1%lo0 prefixlen 64 scopeid 0x4
nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL>
Press RETURN to continue