User guide

3: Client Software Installation
DC 900-1333Q 71
2. Edit the TSI configuration file and change the server parameter
freeway_0 to the
name or IP address of your current Freeway.
A client TSI configuration file might reference the
server parameter more than once, and
must be changed at each occurrence.
Step 2: Run the make file
From the
\freeway\client\test\name directory, enter the following command:
nmake -f makefile.int all
The newly created files will be placed in the
\freeway\client\int_nt\bin directory. For a
description of the Freeway files you have just installed onto your client system, refer to
Appendix B.
3.8 Boot the Freeway
Boot up your Freeway server if it is not already running and attached to your network.
If you have not yet booted the Freeway, refer to Chapter 2 for instructions on booting
the Freeway for the first time.
3.9 Run the Loopback Test
Once your Freeway server is up and running, go to the “bin” subdirectory of the Free-
way directory and run the loopback test depending on your system type as follows:
namealp (on most UNIX systems)
./namealp (on some UNIX systems)
run namealp (on a VMS system)
namealp (on a Windows system)