User guide

3: Client Software Installation
DC 900-1333Q 67
(Where
name is one of the protocol names in Ta ble 3–2 o n page 62.)
When using FTP to copy the protocol software, use BINARY transfer for the protocol
(*.mem) files, and ASCII transfer for the other files.
3.7 Build the Loopback Test Programs
All protocols are supplied with one or more loopback test programs. These programs
are designed to perform a complete data loop test of your Freeway and ICP. These pro-
grams also serve as an example of how you can develop your own client program. A
make file is included that builds the loopback program(s) for each protocol.
All client programs use a transport subsystem interface (TSI) configuration file in order
to “point” to a particular Freeway. For reference in the following sections, Tab le 3– 3 lists
the names of the TSI configuration files for the various loopback programs.
Note
If the server name and Internet address have not already been
added to the
/etc/hosts file during hardware installation, refer to
Section 3.3.2 on page 49.
Table 3–3: Client TSI Configuration Files
AUTODIN (Mode I) AWS STD1300 Milstar
autaltcfg awsaltcfg s13altcfg mstaltcfg
DDCMP Voice Data (VOX) ADCCP NRM Protocol Toolkit
ddcmpaltcfg voxaltcfg nrmaltcfg spsaltcfg
STD1200B
Military/Government
Protocol X.25/HDLC
s12altcfg miltcfg apitcfg