User guide

3: Client Software Installation
DC 900-1333Q 65
Step 3: Insert the Protocol Software distribution CDROM into the appropriate drive
and mount the CDROM. Below is an example of the
mount command (the device name
on your system might be different):
$ mount dka400:
Step 4: Locate the saveset file for your protocol. Depending on the date of your pro-
tocol release, the saveset may be located in a subdirectory under
[parts.PF-200] on the
CDROM, or under a different location. Also, there may be more than one saveset to
install for your particular protocol. Refer to the readme file on the CDROM for more
details. A simple way to find the savesets on the CDROM is to do a directory search for
them as follows:
$ dir dka400:[...]*.bck
Once you have located your protocol software saveset(s), copy the file(s) to your local
directory then use the
set file command to reformat the file(s). Below is an example of
the commands to copy and reformat the saveset file in the local directory:
$ copy dka400:[...]*.bck [user.protogate]
$ set file /attr=(RFM:FIX,RAT:NONE,LRL:32256) bsc_ba.bck
Step 5: Use the backup command to retrieve the Protocol software files from the save-
set file. Use one of the two below examples of the
backup command.
Use the following command if you had previously installed the Freeway directory tree
as a root directory on your disk:
$ backup/new bsc_ba.bck/save [000000...]
Use the following command if you had previously installed the Freeway directory tree
as a subdirectory of an already existing directory (in this example
[user.protogate]):
$ backup/new bsc_ba.bck/save [user.protogate...]