User guide

2: Freeway Installation and Initial Boot
DC 900-1333Q 39
2.2.6 Continue the Freeway Boot
After you have set the correct IP address, hit return to get back to the initial boot main
menu and select 1 to boot the Freeway box. From the Freeway menus, hit 1 and return
repeatedly until you get to the Shutdown Options. Then hit 2 to reboot the system.
As the Freeway boots, it will display several informational messages on the console and
then eventually display the login prompt shown in Figure 2–4.
Freeway initial boot is now complete. The next sections describe additional procedures
that test to see if the Freeway is correctly configured. Once you have determined that the
Freeway is successfully connected on your network, you may remove the local console
device and cable. The Freeway does not require a local console device to be attached in
order to boot up.
Caution
Never connect or disconnect the PS2 keyboard while the Freeway
server is powered on.
Figure 2–4: Freeway Console Login Prompt
+------------ BSD Freeway (fwybsd) ------------+
| |
| Log in as "root" (password "setup"), |
| or as "freeway" (password "password"). |
| |
| For information regarding this system, |
| contact [e-mail] |
| |
+----------------------------------------------+
PicoBSD (devel_fwy) (ttyd0)
login: