User guide

198 DC 900-1333Q
Freeway User Guide
8.2 Install the Freeway Software onto the Boot Server
You need to load the Freeway software onto the boot server in order to create the Free-
way directory tree where the Freeway boot files are stored. Your system administrator
might have already completed this step during the Client software installation proce-
dure described in Chapter 3. If so, skip this section and proceed with Section 8.3 If not,
refer to Section 3.4 on page 52 for instructions on how to install the Freeway software
on your client system. Note that unless you plan to also use your boot server as a devel-
opment system, you do not need to compile the DLI/TSI library on the system.
8.3 Install the Protocol Software onto the Boot Server
You need to load the protocol software onto the boot server for each individual protocol
that you plan to use on the Freeway server. Each different protocol comes on its own
CDROM distribution media. Your system administrator might have already completed
this step during the Client software installation procedure described in Chapter 3. If so,
skip this section and proceed with Figure 8.4. If not, refer to Section 3.6 on page 60 for
instructions on how to install the protocol software on your client system. Note that
unless you plan to also use your boot server as a development system, you do not need
to compile the protocol loopback test programs on the system.