User guide

4: Freeway Interactive Menu
DC 900-1333Q 119
4.8.1.2 Display Hard Disk File
To display a hard disk file as shown in Figure 4–36, enter ‘3’ at the Hard Disk Copy
Options menu. If you change your mind about displaying a file, simply press <return>,
then you will be prompted to press <return> again. You may enter the entire path
name of the file to be displayed.
Note
All Freeway file names are case sensitive.
Figure 4–36: Display Hard Disk File
Enter file name to display: /tmp/boot/bootcfg
#---------------------------------------------------------------------#
# This is the Freeway server boot file for PCI bus ICP2432's. It #
# contains tables and examples of various Freeway and Host #
# configurations. This file is listed in the Freeway's boot parameters #
# under the name #
# "System Boot File Name" #
# #
# There must be a physical device entry for each ICP installed in the #
# Freeway for each ICP to be downloaded #
# #
# Each physical device (ICP) entry currently supports a single service #
# (usually a protocol) and has the following items #
# #
# 1) Device Name (icp0, icp1, icp2, icp3, etc.) #
# 2) Device Card Type (ICP2432) #
# 3) Slave Address (see table below) #
# 4) Bus Number (see table below) #
# 5) Download Script File (see text below) #
# #
# Server wide parameters are at the bottom of the file (see below) #
/tmp/boot/bootcfg 26%