Installation guide

2: Server-Resident Application Software Development
DC 900-1325I 35
-rwxr-xr-x 1 root guest 237519 Mar 14 23:56 mysra
-rw-r--r-- 1 root guest 73440 Mar 14 23:56 mysradcfg.bin
-rw-r--r-- 1 root guest 1608 Mar 14 23:56 mysratcfg.bin
Step 2: Run the SRA simply by entering “./” followed by the SRA executable filename
and then <enter>. (Note that entering just the SRA name without the “./” will also work
on the default Freeway configuration because the path is not restricted, but will not
work if the path is restricted.) Providing that you have the AWS protocol running on at
least one ICP board, and also have two ports connected with a Protogate loopback
cable, you should see results similar to the following example below (user input in
bold):
./mysra
Need help (Y/N) [N]? n
Minutes to run (1-14400) [1]? 1
Number of initial writes (0-16) [1]? 1
ICP board on which to run test (0-15) [0]? 0
Even port number (0, 2, ..., 14) [0]? 0
AWS Asynchronous Port-To-Port Loopback Program.
Test duration in minutes: 1 minute
Number of initial writes on each port: 1
ICP board number: 0
Ports: 0 & 1
OPEN SESSION server0icp0port0
OPEN SESSION server0icp0port1
>>><<><<>>><<><<>>><<><<>>><<><<>>><<><<>>><<><<>>><<><<>>><<>
[several lines omitted]
>>><<><<>>><<><<>>><<><<>>><<><<>>><<><<>>><<><<>>><<><<>>><<>
AWS Statistics Report:
server0icp0port0 server0icp0port1
----------------- -----------------
DCD UP 0 0
CTS UP 0 0
Breaks Received 0 0
Receive overrun errors 0 0
Block check errors 0 0
Parity errors 0 0
Framing errors 0 0
Transmit underruns 0 0
Characters sent 38675 38610
Characters received 38610 38675
Frames sent 595 594
Frames received 594 595