User Manual

START-UP PROCEDURE

NOTE:

If after 30 seconds, it has not recognized the drone, turn off the controller

and repeat Start-Up procedure.

Before ﬂying, the drone and transmitter must be turned on in sequence

and synchronized.

1. Plug the battery into the drone and place it on an even surface. The blue lights

on the drone are at the front and the red are at the back.

2. Turn on the remote control.

3. Both indicators on the drone and the remote will ﬂash while they are syncing.

4. Push the throttle up and then down to sync. You will hear two beeps and the

lights will go steady to indicate the drone has synced.

5. Your drone is now synchronized, and in stand-by mode awaiting Engine

Idle command.

STARTING THE ENGINE; ENGINE IDLE

After synchronizing the drone, move the throttle and direction sticks to the lower

center corners and release to go into Idle mode. The blades will rotate but the

drone will not lift.

Push the throttle up and release to go into Idle Mode.