User's Manual

SLG™ BOARD
SETTINGS AND FUNCTIONS
SLG™ BOARD
SETTINGS AND FUNCTIONS
BLUE – RATE OF FIRE (VALUES 1-20)
The ROF setting is used to set the
maximum rate of fire of the SLG™.
The values do not correspond directly
to a certain Balls Per Second (BPS)
value. You will need to use the table
below to locate your desired
maximum ROF setting. The factory
default is 14 (13.33 BPS). This setting
is used both when the Eye function is
turned on and off.
YELLOW – FIRE MODE (VALUES 1-4)
The fire mode setting is used to select the fire mode of the SLG™. Factory default is semi
automatic mode; one trigger pull shoots out one paintball. The Millennium mode and the PSP
mode follow the rules of the paintball tournament series.
Value 1 – Semi automatic mode
Value 2 – Millennium™ Mode (2008 rules)
Value 3 – PSP™ mode
Value 4 – NXL™
TO CHANGE A VALUE OF A SETTING
1. While in the configuration mode choose the color you wish to change by pulling the trigger.
2. When the LED indicates the color you wish to change, pull and hold the trigger until the LED
starts to flash.
3. The LED will flash as many times as the previous setting was and it will then turn off. Now pull
the trigger as many times as you wish the new setting to be.
4. When done the LED will cycle through all the colors again to indicate setting was saved and
turn back to green. You can now change another setting or quit the configuration mode.
1 10.00 BPS
2 11.10 BPS
3 11.63 BPS
4 11.76 BPS
5 11.90 BPS
6 12.05 BPS
7 12.20 BPS
8 12.35 BPS
9 12.50 BPS
10 12.60 BPS
11 12.82 BPS
12 12.99 BPS
13 13.16 BPS
14
13.33 BPS (default)
15 13.51 BPS
16 13.70 BPS
17 13.89 BPS
18 14.08 BPS
19 14.29 BPS
20 14.49 BPS
21 14.71 BPS
22 14.93 BPS
23 15.15 BPS
24 15.38 BPS
25 15.63 BPS
26 15.87 BPS
27 16.13 BPS
28 16.39 BPS
29 16.66 BPS
30 20.00 BPS
31 22.22 BPS
32 25.00BPS
33 28.57 BPS
34 33.33 BPS
Normal Mode Configuration Mode
WWW.PROTOPAINTBALL.COMWWW.PROTOPAINTBALL.COM
8 9
Increasing ROF too high will increase probability of ball breakage.
If this occurs decrease ROF setting.