User's Manual

LOADERS AND FEED NECK
LOADERS AND FEED NECK
To achieve the maximum
performance of the SLG™
you will need to use a
motorized loader that force
feeds paintballs into the
SLG™ marker. Using a
slower motorized loader or
a non-motorized loader will
work, but the rate of fire will
be reduced.
To fit a loader onto the
SLG™, tighten your loader
into the adjustable feedneck
using a 5/32” allen key.
Loader should now be held
in with a snug fit.
There is no maintenance
needed for the feed neck
besides keeping it clean of
broken paint, dirt and
debris.
AIR/NITROGEN
OPTIONS AND INSTALLATION
AIR / NITROGEN TANK
OPTIONS AND
INSTALLATION
The SLG™ will only work with
Compressed air or Nitrogen air
systems such as the DYE
Throttle air system. Do not use
CO
2
or any other compressed gas.
The output pressure from the air
system has to be between 400 –
850psi.
To install an air system, screw the
tank into the airport as far as it
goes. To remove the air system,
unscrew from the airport. There will
be gas leaking for a few seconds while
you screw the air system out. Notice that
even with the air system removed there
can be gas inside the SLG™ and it can still
fire a paintball. Always treat the marker as
being live and never point it to anything you
don’t intend to shoot.
WWW.PROTOPAINTBALL.COMWWW.PROTOPAINTBALL.COM
1716