User's Manual

TROUBLE SHOOTING GUIDE TROUBLE SHOOTING GUIDE
 •Changethebatteryifnotpositiveaboutit’s
charge.
 •Checkthatthesolenoidcableisattachedto
the blue female connector on the board.
TRIGGER BOUNCE / SLG™ SHOOTING
MORE THAN ONE BALL PER PULL IN SEMI
AUTOMATIC MODE
 •Raisethetriggersensitivitylevelinthe 
configuration mode.
 •Check that the trigger is not adjusted too short.
 •Makesurethereisatriggerspringinsidethe
frame.
 •Besuretheboltisscrewedtogethersnugly.
ERRATIC VELOCITY / SLG™ WON’T FIRE
SLG™ FIRES BUT BALLS ARE DROPPING OFF
OR NOT EVEN COMING OUT OF THE BARREL
 •Makesurethebatteryisgood.
 •Makesureboltisclean,welllubed,andmoves
well. If there is too much friction in the bolt it
will cause the SLG™ to shoot down.
 •Makesureairsystemisscrewedinalltheway.
 •Makesureairportscrewisadjustedcorrectly.
 •MakesurethefrontbumperO-ringisnot
blocking the inlet hole located on the back
of the bolt.
SLG™ WILL NOT FIRE BUT SOLENOID CLICKS
 •Pressthebleedbuttononthebackofthebolt
several times, listen for bolt moving rear wards.
If the bolt is still not moving, depressure the
BREAKING PAINT
 •Makesureyouusehighqualitypaintballsand
that they are stored according to the
manufacturers instructions.
 •Checkthat#14O-ringonbolttipisinplace
and in good condition.
 •Makesureyourloaderisworkingandthatthe
  rateofreisnotsethigherthanthemaximum
feed rate of the loader.
 •Checkthatthebarrelyouareusingisnottoo
tight for the paintballs you are using.
 •Eyesareclean/on.
NOTES:
SLG™ and remove back and bolt, add lube to
the bolt and reassemble.
FIRST SHOT IS TOO HIGH
 •ChangetheSeatinsidetheHyper3™regulator.
For dis-assembly instructions consult the
technical section on page 21.
VELOCITY IS NOT CONSISTENT
 •Makesurethepaintballsyouareusingtthe
barrel good and are consistent in size.
The stock barrel with the SLG™ is .690 size.
You should be able to blow the paintball
through the barrel but they should not roll
through the barrel on their own.
 •Removetheboltkitandre-lubeit.Changeany
o-rings causing a lot of friction. Make sure
#014 O-ring in bolt tip is in place and in good
condition.
 •Changethebattery.
 •CheckthattheHyper3™regulatorisworking
good and that the pressure is consistent.
A separate regulator testing tool is available
for this. If needed, dis-assemble and change
worn out O-rings in the Hyper3™ regulator.
OTHER CATEGORIES
DOUBLE FEEDING
 •Ifyougettwoballsringatoncechecktosee
that the Ball Detents are not stuck down.
 •MakesuretheBallDetentsarenotexcessively
worn.
W W W . P R O T O P A I N T B A L L . C O MW W W . P R O T O P A I N T B A L L . C O M
26 27